Operation; Hanging On/Removing The Grass Bag; Level Gauge; Emptying The Grass Bag - Grizzly Tools ERM 1743-20 Traduction De La Notice D'utilisation Originale

2. Fix the bottom bar (3) using the
two screws and butterfly nuts
(2a).
3. Fix the curved handle (1) using
the enclosed screws (16) and
the wing nuts (2b) on the lower
bar (3). There are two possible
positions.
4. Clip the cable hooks (10) into
the bar (3) and the handle (1) to
fasten the cable.
When both wing nuts are loos-
ened, the curved handle can be
folded down for storing the equip-
ment. Ensure that the power cable
is not caught.

Operation

Hanging On/Removing the
Grass Bag
1. To hang on the grass bag (4), lift
the collision guard (9) and hang
on the grass bag. Fold the col-
lision guard (9) onto the grass
bag (4). It holds the grass bag
in the correct position.
2. To remove the grass bag (4),
lift the collision guard (9) and
detach the grass bag. Fold the
collision guard (9) back onto the
mower housing.
Do not work with the lawnmower
without the collision guard or
lawn box. There is a risk of in-
jury.

Level gauge

The level gauge (17) is located on the
side of the grass catcher (4).
Flap (17) open:
grass catcher (4) empty
Flap (17) closed:
grass catcher (4) full
The level indicator (17) works
when the device is in operation.

Emptying the Grass Bag

To empty the grass collection bag, also
use the bottom bag handle (4).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
1. Hold the cut height adjusting
lever (5) and guide it past the
indent to the desired cut height
setting.
2. The handle (8) may be used
to help, in order to prevent to
mower rolling away.
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 –
60 mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.
GB
29