Initial Operation; Mounting Grip Rod; Installing The Grass Collection Box - Grizzly Tools BRM 42-125/2 BS Traduction De La Notice D'utilisation Originale

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Before starting the device, you must
- mount the grip rod,
- fill in motor oil,
- fill in petrol,
- mount the grass catcher if necessary,
- set the cutting height if necessary.

Mounting grip rod

Make sure that the Bowden cable
( 6) is not crushed during the
assembly of the grip handle.
Mounting the lower bars:
1. Remove the two star grip
screws (20) from the machine
housing (15).
2. Attach the ends of the lower
handlebars (4) to the machine
housing (15).
3. Screw the two lower handlebars
(4) tight with the enclosed star
grip screws (20) on the right
and left of the mounting on the
machine housing (15).
Mounting the upper grip:
4. Screw the upper grip (1) to the
right and left of the lower han-
dlebars (4) using the included
quick-release levers and nuts
(24).
5. Fold out the upper grip (1)
(small picture) and press the
locking lever (24) towards the
handlebar.
6. Fasten the Bowden cable (6)
using a cable clamp (5) to the
bottom handle (4).
Installing the Grass Collection
Box
Caution: Do not operate the equip-
ment with the grass collection
box or impact protection installed
incompletely. Risk of injury!
Assemble grass catchment
basket:
1. Loosen the Phillips screw (30)
on the carrying handle (22).
2. Place the carrying handle (22)
on the upper side of the grass
collector (19) and screw it tight
with a Philips screw (30) from
below.
3. Push the grass collection box
rod (28) into the upper side of
the grass collection box (19)
and screw it tight with the two
Philips screws (29) from above.
4. Place the net of the grass col-
lection box into the groove on
the upper side of the grass col-
lection box (22). It will lock into
place.
5. Pull plastic loops (27) over bas-
ket rods.
Fixing the Grass Collection
Box onto the Equipment:
6. Lift up shock protection (21).
7. Hook the grass collection box
(19) into the mounting provided
for this (31) on the rear of the
equipment.
8. Release the impact protection
(21). It holds the grass collec-
tion box in position.
GB
85