Installing Wings - PARKZONE Stinson Reliant SR-10 BNF Manuel D'utilisation

Installing Wings

bottom of the wing into the top of the fuselage.
2. Attach the two (2) aileron connectors to the aileron
on the cockpit windshield.
4. Attach the wing to the fuselage using two (2) screws.
use of body clips is recommended. Although the L-pins provide
a more finished appearance, they require tape for installation
and are not as easily removed as the body clips.
All manuals and user guides at all-guides.com
5.
using two (2) RC body clips or two (2) L-pins.
for storage. Finish on L-pins or body clips may not match
photos.
strut in the fairing under the wing.
8.
two (2) RC body clips or two (2) L-pins.
9.
on the struts.
Install left and right struts in fairings in the lower fuselage
Attach the wing struts to the fairings under the wing using
Where used, apply tape to the four (4) L-pins to hold them
EN
9