Installing Horizontal Tail - PARKZONE Stinson Reliant SR-10 BNF Manuel D'utilisation

EN

Installing Horizontal Tail

1. Install horizontal tail (the elevator control horn is on the
bottom of the left side of the horizontal tail) from the left side of
the fuselage through the hole in the rudder and fuselage.
2. Cover the rear portion of the hole in the rudder using left
and right cover plates and two (2) screws.
screw.
10
All manuals and user guides at all-guides.com
3.
top and bottom of fuselage.
4. Install elevator clevis on outermost hole of control horn (on
horizontal tail, under left side).
5. Slide silicone band over clevis to keep the clevis on the
control horn.
Apply four (4) pieces of tape to horizontal tail sections and