Installing Horizontal Tail; Installing Transmitter Batteries; Low Battery Alarm; Transmitter And Receiver Binding - PARKZONE P-51D MUSTANG BL RTF Manuel D'utilisation

Installing Horizontal Tail

1. Install the horizontal stabilizer in the fuselage mount.
2. Apply 4 pieces of tape (total) on the top and bottom of horizontal
tail at the fuselage mount.
3. Attach clevis to elevator control horn.
4. When needed, disassemble in reverse order.

Installing Transmitter Batteries

The DX4e requires 4 AA alkaline, heavy-duty or rechargeable batteries.
Remove the battery door and install 4 AA batteries. Make sure the polarity
of each battery corresponds with the diagram in the battery holder.
Replace the battery door.

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter. You
need to 'bind' your chosen Spektrum
Note: Your DX4e and P-51 Mustang should already be bound for you. However,
if you ever need to re-bind, please follow these simple instructions below.
Note: When using a Futaba transmitter with a Spektrum DSM module, you must reverse the throttle channel.
Binding Procedure Reference Table

1. Read transmitter instructions for binding to a receiver (location of transmitter's Bind Control).
2. Make sure transmitter is powered off.
3. Move the transmitter controls to neutral (flight controls and trim levers for rudder, elevators and ailerons) or to low positions
(throttle and throttle trim).
4. Install a bind plug in the receiver bind port.
5. Connect the flight battery to the ESC. LED on receiver will flash rapidly.
6. Power on the transmitter while holding the transmitter bind button. Refer to your transmitter's manual for binding button or switch instructions.
7. When the receiver binds to the transmitter, the light on the receiver will be solid and the ESC will produce a series of sounds.
The series of sounds is a long tone, then 3 short tones that confirm the LVC is set for the ESC.
8. Remove the bind plug from the bind port.
9. Safely store the bind plug (some owners attach the bind plug to their transmitter using two-part loops and clips).
10. The receiver should keep the binding to the transmitter until another binding is done.
DSM2 /DSMX technology equipped aircraft transmitter to the receiver for proper operation.
™ ™ ™
Tape (4 pcs.)

Low Battery Alarm

When the battery voltage drops below 4.7 volts, an alarm sounds and the volt-
age LEDs flash. The batteries must be replaced immediately. If this happens
while flying, land your aircraft as soon and as safely as possible.
BIND PLUG
EN
Top of Tail
5