Charging The Flight Battery; The Battery Charging Process - PARKZONE Stinson Reliant SR-10 BNF Manuel D'utilisation

Charging the Flight Battery

pack with a Li-Po specific charger only (such as the included
during the charge process. Failure to follow the instructions
properly could result in a fire. When charging, make certain the
battery is on a heat-resistant surface. Charge the flight battery
while assembling the aircraft. Install the fully charged battery to
perform control tests and binding.

The Battery Charging Process

1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make sure it is not damaged
e.g., swollen, bent, broken or punctured.
2. Attach the input cord of the charger to the appropriate power supply (12V accessory outlet).
3. When the Li-Po charger has been correctly powered up, there will be an approximate 3-second delay, then an audible
4. Turn the control on the Amps selector so the arrow points to the charging rate required for the Battery (see chart, for
battery begins charging.
5. Move the cell selector switch to 2-cell or 3-cell for your battery.
the life of the battery.
continuously.
9. Always unplug the battery from the charger immediately upon completion of charging.
Battery Capacity
300-400mAh
500-1000mAh
1000-1500mAh
1500-2000mAh
2000mAh +
All manuals and user guides at all-guides.com
ONLY
®
Maximum Charge Rate
300mA
500mA
1A
1.5A
2.0A
DC Li-Po Balancing Charger Features
Specifications
capacity of 300mAh
3S 11.1V 1800mAh Li-Po Battery Pack
The ParkZone 3S Li-Po battery pack features a balancing
lead that allows you to safely charge your battery pack
when used with the included ParkZone Li-Po balancing
charger.
battery can result in serious damage, and if left charging
charging Li-Po batteries.
EN
5