Transmitter And Receiver Binding - PARKZONE Stinson Reliant SR-10 BNF Manuel D'utilisation

Transmitter and Receiver Binding

Binding is connecting a transmitter to an aircraft receiver wirelessly or electronically so the aircraft receiver recognizes the transmit-
The Stinson Reliant requires a DSM2 full range (high power) transmitter. The list below is Spektrum™ or JR® DSM2-equipped full
List is complete as of this printing. Additional compatible transmitters may be available.
Additional Binding Information
Before each flight, power on the transmitter and wait about five (5) seconds
scans and secures two radio frequencies for aircraft control. When the flight
battery is connected too quickly for the transmitter to make frequency
selection, the transmitter and receiver may not connect. When there is no
connection, leave the transmitter powered on, disconnect the flight battery
then connect the flight battery to the receiver.
1. Read transmitter instructions for binding to a receiver (location of transmitter's Bind control).
2. Make sure transmitter is powered off.
3. Install a bind plug in the servo extension in the battery compartment.
4.
5.
positions (throttle, throttle trim, and flight control trims).*
Power on the transmitter while holding the transmitter bind button or switch. Refer to your
transmitter's manual for binding button or switch instructions.
7.
8. Remove the bind plug from the servo extension in the battery compartment and stow extension.
9. Safely store the bind plug (some owners attach the bind plug to their transmitter using two-part
loops and clips).
10. The receiver should keep the binding to the transmitter until another binding is done.
* The throttle will not arm if the transmitter's throttle control is not put at the lowest position.
If problems are encountered, obey binding instructions and refer to transmitter troubleshooting guide for other instructions.
If needed, contact the appropriate Horizon Product Support office.
All manuals and user guides at all-guides.com
Binding Procedure Reference Table
EN
7