Control Surface Travel Measurement - PARKZONE Stinson Reliant SR-10 BNF Manuel D'utilisation

Control Surface Travel Measurement

Factory Setting for Control Surface Travel
100% on high rate and at 70% on low rate. These dual rates cannot
adjustable travel volume (ATV).
The factory settings provide a moderate amount of control surface
movement. Clevises are installed in the outermost holes of the
control horns (away from the control surface).
Low Rate
Aileron 10mm up/7mm down
10mm up/down
Rudder 17mm left/right
All manuals and user guides at all-guides.com
High Rate
15mm up/10mm
Flap
down
15mm up/down
22mm left/right
Servo
Factory Setting for Rudder and Elevator
Servo Arms and Pushrods
1/2 Flap
15mm
EN
Rudder
Servo
Front of
aircraft
Full Flap
25mm
13