Cleaning And Storing The Device; Emptying The Dust Container And Cleaning The Filter - Cleanmaxx VC-S1001 Mode D'emploi

Cleaning and Storing the Device

CAuTIOn!
❐ Before you do any cleaning and before you remove the dust container, always remove the
mains plug from the plug socket first.
❐ Never immerse the motor housing in water or other liquids.
❐ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the device.
These could damage the surface.

Emptying the Dust Container and Cleaning the Filter

The dust container (8) should be emptied at regular intervals to maintain good suction force.
You can look through the transparent housing to see how much dirt has accumulated inside.
1. Hold the hand-held vacuum cleaner vertically, with the suction opening pointing down-
wards, over an open rubbish bin.
6. Allow all parts to dry completely in the air before you insert them again.
CAuTIOn! Do not under any circumstances use a hair dryer. Do not insert the
filter under any circumstances if it is still damp!
7. Place the fabric tape around the filter and close the Velcro fastener.
8. Place the filter back into the dust container so that it sits directly on the housing wall all
the way round.
CAuTIOn! Never use the vacuum cleaner without the filter inserted.
9. First place the dust container at the bottom of the device and then flip it shut. The dust
container must be firmly locked in place at the top and bottom of the device.
01328_9_DE-GB-FR-NL_V0.indb 22
2. Hold down the release button (9) of the dust container and
carefully remove it.
3. Carefully remove the filter (5) and empty the dust container.
4. A piece of fabric tape is attached around the filter. Open the
Velcro fastener of the tape and gently tap out the filter and
the tape.
5. Wash the dust container, the filter and the fabric tape if
necessary under cold, running water.
CAuTIOn! Do not wash the filter and the fabric
tape in the washing machine.
22
07.09.11 12:28