NSK NLZ E Mode D'emploi page 30

Select the Mode (NLZ E only)
1
Select the gear ratio of the attached handpiece
3
General Application Mode 1:5, 1:1, 4:1, 6:1
Rotary Endo Mode 1:1, 4:1, 6:1
Reciprocating Endo Mode 6:1 (Fixed)
Make sure that the correct gear ratio of the handpiece is selected before checking process, otherwise it will lead to
wrong results.
Hold down the Check Key for more than 2
2
seconds to start up the Contra-Check. The "GEAr"
and the gear icon will start blinking after a short
beep sound.
1
2
3
NOTICE
29
Operation Procedure