Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Components
No.
Key
1
2
3
4
5
6
Name
Display
Power Key
-
G
Memory Key
B
Torque Key
(NLZ E)
-
Setting Key
-
(NLZ)
A
Speed Key
Check Key
C
D
Light Key
10
Function
Press once to turn ON the power. When the power is ON,
hold it down for more than two seconds to turn OFF the
power
In General Application Mode:
Motor speed can be adjusted between 100 and
-1
40,000 min
.
In Rotary Endo Mode:
Motor speed can be adjusted between 100 and
-1
6,000 min
.
*Display value changes interlocked with the gear ratio.
When gear ratio is set by each time pressing this key you
can adjust the torque.
Rotary Endo Mode
Gear Ratio Torque Range (N·cm) Increment (N·cm)
1:1
0.3 - 3.0
4:1
0.8 - 6.0
6:1
1.0 - 6.0
Change the setting as described in "3-8 Changing the
settings for various functions"
Change the setting as described in "3-8 Changing the
settings for various functions"
In General Application Mode:
Motor speed can be adjusted between 100 and
-1
40,000 min
.
In Rotary Endo Mode:
Motor speed can be adjusted between 100 and
-1
6,000 min
.
*Display value changes interlocked with the gear ratio.
Check the status of the handpiece as described in "4-4
Contra-Check Function"
Set light intensity (Strong·Moderate·Weak·OFF)
By each time pressing this key you can change the
volume from OFF -> intensity 1 -> intensity 2 -> intensity
3 and then back to OFF again
* The light can be turned on for 5 seconds by pressing the
key while the motor is stopped.
0.1
0.4
1.0 - 1.2:0.2
1.2 - 6.0:0.6
Publicité
Table des Matières
