Cleanmaxx SV-618 Mode D'emploi page 49

Storage
CAUTION!
❐ Put the device back into its storage position only once it has completely cooled down and it
has been emptied of water. Allow the device to cool down for at least 30 minutes.
1. Swicht off the device and remove the mains plug from the mains socket.
2. Allow the device to cool down for at least 30 minutes.
3. Press the steam release button to completely discharge any remaining steam.
4. Empty the water reservoir completely.
5. Remove all accessories from the device.
6. Store the device in a cool, dry place out of the reach of children or animals.
Troubleshooting
Problem
The device does • The device is not connected to a plug socket.
not work. / The Check whether the device is connected to a plug socket.
control lamp does
• The device is swiched off.
not light up.
Swith on the device with the on/off switch.
• The plug socket does not work.
Connect the device to a different plug socket.
The device does • The water reservoir is empty.
not work even Fill the water reservoir in the manner described in the "Putting into
though the control Operation" chapter, "Filling the Water Reservoir" section.
lamp lights up.
No steam or • The device is not connected to a plug socket.
hardly any steam is Check whether the device is connected to a plug socket.
emerging.
• The device is swiched off.
Swith on the device with the on/off switch.
• The steam release button has not been pressed.
Press the steam release button during use.
• The water reservoir is empty.
Fill the water reservoir in the manner described in the "Putting into
Operation" chapter, "Filling the Water Reservoir" section.
01321_DE_Dampfbesen_Handdampfreiniger_V4.indb 48 01321_DE_Dampfbesen_Handdampfreiniger_V4.indb 48
All manuals and user guides at all-guides.com
Possible cause / solution
48
21.12.12 11:07 21.12.12 11:07