Removing The Rear Cover; Connecting The Ac Power Cord; To Use The Ac In Socket On The Monitor - Sony LMD-1951MD Instructions D'utilisation

Removing the Rear
Cover
The rear cover is attached to the terminal at the back.
Before you connect cables to the terminal, remove the
rear cover as follows.
1
Loosen the two screws on both sides.
2
Slide the rear cover downward.
60
Removing the Rear Cover / Connecting the AC Power Cord
Connecting the AC
Power Cord
Connect the supplied AC power cord as illustrated.
Two kinds of AC plug holders are supplied with this
unit. Use the AC plug holder that fits the AC power cord
most securely.
Note
Avoid plugging the AC power cord into the AC IN
socket while connecting the optional AC adaptor (AC-
110MD) to the DC IN connector.
To Use the AC IN Socket on the
Monitor
1
Plug the AC power cord into the AC IN socket on
the rear panel. Then, attach the AC plug holder
(supplied) to the AC power cord.
AC plug holder
(Supplied)
2
Slide the AC plug holder over the cord until it
locks.
To disconnect the AC power cord
Pull out the AC plug holder while pressing the lock
levers.
AC IN socket
AC power cord