Color Temp/Space Menu; User Control Menu - Sony LMD-1951MD Instructions D'utilisation

COLOR TEMP/SPACE menu

The COLOR TEMP/SPACE menu is used for adjusting
the picture white balance or color space.
You need to use the measurement instrument to adjust
the white balance.
Recommended: Konica Minolta color analyzer CA-210
COLOR TEMP/SPACE
C O L O R T E M P :
M A N U A L A D J U S T M E N T :
A D J U S T G A I N :
A D J U S T B I A S :
C O P Y F R O M :
C O L O R S PA C E :
Submenu Setting
COLOR TEMP Selects the color temperature from
among "HIGH", "LOW", "LOW2",
"USER" and "USER2".
MANUAL If you set the COLOR TEMP to
ADJUSTMENT USER or USER2 setting, the item
displayed is changed from black to
white, which means you can adjust
the color temperature.
The set values are memorized.
• ADJUST GAIN: Adjusts the
• ADJUST BIAS: Adjusts the
• COPY FROM: If you select
COLOR SPACE Selects the color space either ITU-
709 or OFF. OFF sets the color
space to the original color
reproduction of the LCD panel.

USER CONTROL menu

The USER CONTROL menu is used for adjusting the
picture.
Items that cannot be adjusted depending on the input
signal are displayed in black.
For details of input signals and adjustable/setting items,
see page 57.
xxxxxx
xxx
x
color balance (GAIN).
color balance (BIAS).
"HIGH", "LOW" or
"LOW2", the white balance
data for the selected color
temperature will be copied
in the "USER" or "USER2"
setting.
For the video input
USER CONTROL 1/3
AU T O C H R O M A / P H A S E
AU T O A D J VA L U E :
S TA R T :
USER CONTROL 2/3
S U B C O N T R O L
C O N T R A S T :
B R I G H T N E S S :
C H R O M A :
P H A S E :
A P E R T U R E :
B A C K L I G H T :
USER CONTROL 3/3
P I C T U R E C O N T R O L
A C C :
C T I :
V S H A R P N E S S :
I N P U T S E T T I N G
S H I F T H :
S H I F T V :
Submenu Setting
AUTO CHROMA/ Adjusts color intensity (CHROMA)
PHASE and tones (PHASE).
• AUTO ADJ VALUE: Selects
• START: The auto adjustment
xx
x
x
x
x
x
x
xx
x
x
xxx
xx
ON or OFF of the auto
adjustment. When you set
to OFF, this parameter is
reset to the factory setting.
When you set to ON, the
automatically adjusted value
is enabled.
starts when you display the
color bar signals (Full/
SMPTE/EIA) on the screen
and press the ENTER
button. After adjusting the
color intensity, press the
MENU button to clear the
adjustment screen. After the
adjustment is done correctly,
the AUTO ADJ VALUE is
automatically set to ON.
69
Adjustment Using the Menus