Attaching The Blade Spur; Attaching The Front Wheel - Stihl MH 610 Notice D'emploi

6 Assembling the Cultivator
► Push folding retainers (3) through the bores in drive
shaft (2) and close the securing clips.
Running wheels (1) are secured.
6.2.2 Removing the Running Wheels
► Stop the engine.
► Pull out the folding retainers.
► Remove the running wheels.
► Push the folding retainers through the bores in the drive
shaft.
The folding retainers are kept in place.
6.3

Attaching the Blade Spur

► Fit blade spur (1) into adapter (2) from below so the bore
on adapter (2) aligns with the lowermost bore on blade
spur (1).
► Insert pin (3).
► Push retaining pin (4) through the bore in pin (3).
► Screw in screw (5) and tighten firmly.
The blade spur is secured.
0478-404-9902-A
6.4

Attaching the Front Wheel

► Detach retaining pin (1) and remove pin (2).
► Pull out retaining pin (3), unscrew castellated nut (4),
remove washer (5) and bolt (6).
► Slide front wheel (7) onto frame (8) so the bores align.
► Insert bolt (6) into the rear bore.
► Place washer (5) on bolt (6).
► Screw on castellated nut (4) and tighten.
► Push retaining pin (3) through castellated nut (4).
Castellated nut (5) is secured.
► Insert pin (2) through the front bore.
► Push retaining pin (1) through the bore in pin (2).
Pin (2) is secured and front wheel (7) is locked in position.
The front wheel must not be dismantled again.
English
13