NOTE!
After each filter cartridge replacement, flush the device for 5 minutes.
f
6.5 Installation and operation of the BWT RO app
If the BWT RO app is not yet installed on your mobile phone, please scan the QR code below.
This will take you to the website where you can download the app. The app can also be down-
loaded under the following internet address: www.bwt-wam.com
PLEASE NOTE!
Ensure that Bluetooth is activated on your end device.
f
When installing the app for the first time on an iOS end device, download the app and proceed as follows to activate it: Settings /
f
General / Device Management / BWT Aktiengesellschaft / Trust BWT Aktiengesellschaft
The app is a purely offline application. No data is transmitted to BWT.
f
7 Troubleshooting
7.1
Overview of the status and alarm LEDs
Status
LED colour
ready
green flashing light
ready
blue flashing light
working
green light
working
blue light
working
yellow light
fault
red light
Device status
Device is on standby
Device is on standby.
Mobile device connected to RO via Bluetooth
RO device in production
Mobile device connected to RO via Bluetooth
WCF alarm triggered
Error message displayed in app
(constant or flashing)
You will find the operating instructions for the
BWT RO app attached (Appendix).
(Chapter 7.2)
19