Burkert eCONTROL 8611 Guide De Démarrage Rapide page 39

ConfigurationLevel
FILT Enter filter factor ( 2 - 20)
Selection of
controller parameters
PARA
KP1
KP2 *
)
TREG *
)
TN *
)
DEAD
KP_T *
)
TN_T *
)
DE_T *
)
Effective direction
INV
Zero point shut-off (if default < 2 % of the set-point value range). Display only for INV = NO
ZERO
STRT * )
BACK
B_IN
Fig. 21: Operating structure of the configuration level - 7 of 12
Type 8611
* The display depends on the control variable set in the MODE menu (see Fig. 15)
)
KP1, Pproportional coefficient 1
KP2, proportional coefficient 2
Cycle time for controller [s] (display only for MODE = PVC, 3P – T, 2P – T,)
Reset time [s] (display only for MODE = SCV, 0 – 10, 4 – 20, 2P – T, 3P – T,)
Dead zone absolute. Unit and display of decimal place analogous to UNIT.
Proportional coefficient for cascaded temperature control (display only for MODE = T + F)
Reset time in [s] for cascaded temperature control (display only for MODE = T + F)
Dead zone absolute for cascaded temperature control (display only for MODE = T + F).
Not inverted or direct control
NO
YES Inverted control
Zero point shut-off is deactivated
NO
Zero point shut-off is activated
YES
Definition of start value for manipulated variable
(display only for MODE = SCV, 0 – 10, 4 – 20, 1P – T, 3P – T)
english
39