Burkert eCONTROL 8611 Guide De Démarrage Rapide page 16

7.3.1. installation in a control cabinet
• Prepare control panel recess with the dimensions 45mm x 45mm
(corner radius 3mm).
• Place the supplied seal on the housing.
• Insert the controller from the front into the control panel recess.
• From the rear, snap the 4 supplied fastening elements into place
and fasten using a screwdriver.
4 Fastening elements
Seal
Fig. 7: Installation elements
16
Fig. 8: Installed controller
english
Type 8611
Assembly
recommended line cross sections for the control cabinet
model:
Cross
section
min.
Cross section for 0.2 mm²
flexible lines
Cross section for 0.25 mm²
flexible lines with
cable end sleeve
without plastic
sleeve
Cross section for 0.25 mm²
flexible lines with
cable end sleeve
with plastic sleeve
Tab. 3: Recommended line cross sections
Cross
Minimum
section
length
max.
1.5 mm² 10 mm
(stripping)
1.5 mm² 10 mm
0.75 mm² 10 mm