Burkert eCONTROL 8611 Guide De Démarrage Rapide page 30

10.2. operating state Manual
Briefly press (< 1 s) the ENTER key to go to the MANUAL operating
state.
The operating state is indicated on the display by a hand symbol.
10.3. specific menu options of
process and ratio control
The display of some menu options differs for the process and the
ratio control. This is described in detail in the respective menu
descriptions.
The control type is specified by the control variable selected in the
MODE menu:
• Process control: is active if all control variables have
been selected in the MODE menu
except forRATI.
• Ratio control is active if the RATI control variable has
been selected in the MODE menu
30
english
Type 8611
Functions,ProcessOperatingLevel
10.4. Menu options in the Manual
operating state
set-point value default for process control
SET
• Menu option is displayed for process control.
• Is not available if external set-point value default is
selected.
ratio factor default for ratio control
RFAC
• Menu option is only displayed for ratio control
(MODE = RATI).
• Is not available if external set-point value default is
selected.
When BACK is displayed on the display, press the
BACK
ENTER key briefly to switch to AUTOMATIC oper-
ating state.
When an arrow key is pressed, the next or respec-
tively the previous menu option is displayed.
display of the analog inputs and outputs and
TEST
the digital inputs.
adjusting the controller parameters (Code must
PARA
be entered if code protection is activated).
Manual opening and closing of the connected
VALV
valves.
Tab. 13: Menu options of the process operating level