Burkert eCONTROL 8611 Guide De Démarrage Rapide page 36

UNIT
Selection of set-point value default and scaling of external default
SETP ** EXT
)
RFAC ***
) INT
Selection and scaling of sensor input
4 – 20
S_IN ****
)
0 – 10
Selection and scaling of analog output
AOUT 4 – 20
0 – 10
CALI
Fig. 18: Operating structure of the configuration level - 4 of 12
36
4 – 20
Enter scaling
0 – 10
Enter scaling
Output of flow-rate as standard signal (only for control variable MODE = F, T + F, T - F)
FLOW *
)
Output of temperature as standard signal (only for control variable MODE = T, T + F, T - F)
TEMP *
)
PRES * Output of pressure as standard signal (only for control variable MODE = P)
)
LEVL* Output of filling level (only for control variable MODE = L)
)
VAL * Output of process value (only for control variable MODE = X or T and UNIT = NU)
)
Output of actuating element position (only for actuating element type MODE = SCV)
POS * )
Q1 * Output of flow-rate Q1 for ratio control (control variable MODE = RATI)
)
Q2* Output of flow-rate Q2 for ratio control (control variable MODE = RATI)
)
Output of ratio factor RFAC for ratio control (control variable MODE = RATI)
RFAC *
)
Enter scaling
english
Type 8611
ConfigurationLevel
** The SETP menu option is only displayed for
)
process control. Consequently for all control vari-
ables set in the MODE menu except for RATI.
*** The RFAC menu option is only displayed for ratio
)
control. Consequently only if the RATI control variable
is set in the MODE menu.
The S_IN menu option is only displayed if standard
**** )
signal (NORM) was selected as sensor input.
The display depends on the control variable set in
* )
the MODE menu.