Table des Matières
Publicité
The server will respond with:
TERANEX DEVICE:
Model name: (displays the Teranex model name)
Software Version: (displays the checksum of the installed software release)
FPGA Version: (displays the FPGA version of the installed software release)
Protocol Commands
Align
The Align commands are available in the Teranex 3D only. They may be used to adjust the
alignment between 3D stereoscopic left and right eye signals. In the Teranex 3D LCD menus,
these functions are included in the "Camera Align" menus. Size (Zoom), Position and Trim
commands are included in this block. Other Camera Align functions, Flip and Rotation, are
found in the Mode3D command block.
To use the Align commands, the Teranex 3D must be receiving left and right eye video signals
and must be in the 3D Align mode. Enter the commands below and then proceed with
adjustments via the Align commands.
MODE3D:↵
3D mode: 3DModeAlign↵
↵
ACK↵
↵
MODE3D:↵
3D mode: 3DModeAlign↵
...
↵
Size (Zoom), Position and Trim Commands
The commands below permit you to adjust the left and right eye signals independently. For
example, the "Align pos X left:" adjusts the horizontal position of the left eye , whereas "Align
pos X right:" adjusts the horizontal position of the right eye. For example, to move the position
of the left eye 20 pixels to the right enter:
ALIGN:↵
Align pos X left: -20↵
↵
ACK↵
↵
ALIGN:↵
Align pos X left: -20.000000↵
Align pos X right: 0.000000↵
Align pos Y left: 0.000000↵
Align pos Y right: 0.000000↵
↵
Protocol Commands
Command
Align size X left: 0.000000
Align size X right: 0.000000
Command Description
Set the Horizontal Size (X) (Zoom) value for the Left Eye.
Negative values decrease size; positive values enlarge the
image. Default = 0
Set the Horizontal (X) Size (Zoom) value for the Right Eye.
Negative values decrease size; positive values enlarge the
image. Default = 0
Informations pour les développeurs
329
329
Publicité
Table des Matières
