Table des Matières
Publicité
Mode, Input and Output Commands
Command
3D mode:
2D3D intensity:
2D3D depth:
3D output:
3D input:
Rotation and Tilt Commands
The commands below may be used to adjust the alignment between the left and right eye
signals of a 3D stereoscopic source. In the Teranex 3D LCD menus, these functions are part of
the "Camera Align" menu.
Rotation (Roll, Tilt and Toe-in) and Flip commands are included in this block. Other Camera Align
functions, Size, Position and Trim, are found in the Align block.
First, enter the "MODE3D:" block command, then use the "3D mode:" command to select
"3DModeAlign" and proceed with the adjustment commands below.
Example:
MODE3D:↵
3D roll left: 20↵
↵
ACK ↵
↵
MODE3D: ↵
3D roll left: 20 ↵
3D roll right: 0 ↵
↵
Command
3D roll left:
3D roll right:
3D tilt left:
3D tilt right:
Command Description
Enable the 3D processing modes of the Teranex 3D.
Values are: 3DModeOff, 3DModeConvert, 3DMode2Dto3D,
3DModeAlign
Adjust the Intensity level when 3D Mode is set to
2D to 3D. Range is --40 to +40. (Default = 15)
Adjust the Depth level when 3D Mode is set to
2D to 3D. Range is -12 to +12. (Default = 0)
Select the 3D output signal format: Values are: 3DFullFrame,
3DSideBySide, 3DTopBottom, 3DLinebyLine
Select the 3D input signal format: Values are: 3DFullFrame,
3DSideBySide, 3DTopBottom, 3DLinebyLine
Command Description
Adjust the Left Eye Z axis image rotation.
Range is -400 to +400 units. (Default = 0)
50 units = 1 degree. (1 unit = 0.02 degree)
Adjust the Right Eye Z axis image rotation.
Range is -400 to +400 units. (Default = 0)
50 units = 1 degree. (1 unit = 0.02 degree)
Adjust the Left Eye X axis image tilt.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
Adjust the Right Eye X axis image tilt.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
Informations pour les développeurs
336
336
Publicité
Table des Matières
