Table des Matières
Publicité
Video Adjust
Command
Red:
Green:
Blue:
Luma low:
Luma high:
Chroma low:
Chroma high:
Aspect fill luma:
Aspect fill Cb:
Aspect fill Cr:
Video Advanced
Command
Clean cadence:
Scenecut detect:
Source type:
FRC aperture:
Processing:
Video Input
Command
Auto detection enabled:
Auto detection prefer PsF:
Command Description
Set value of Red color correction control.
Range is -200 to +200 (Default = 0)
Set value of Green color correction control.
Range is -200 to +200 (Default = 0)
Set value of Blue color correction control.
Range is -200 to +200 (Default = 0)
Set luminance low level value to clip undershoots.
Range is 4 to 1018 (Default = 4)
Set luminance high level value to clip overshoots.
Range is 5 to 1019 (Default = 1019)
Set chrominance low level value to clip undershoots.
Range is 4 to 1018 (Default = 4)
Set chrominance high level value to clip overshoots.
Range is 5 to 1019 (Default = 1019)
Set luminance (Y) value for letterbox or pillarbox fill color.
Range is 64 to 940 (Default = 64)
Set B-Y value for letterbox or pillarbox fill color.
Range is 64 to 960 (Default = 512)
Set R-Y value for letterbox or pillarbox fill color.
Range is 64 to 960 (Default = 512)
Command Description
Enable Clean Cadence processing. False = OFF;
True = ON (Default = False)
Enable scene cut detection. False = OFF;
True = ON (Default = True)
Values are: Auto, Video, Film
Values 0, 1, 2, 3.
This command sets the processing latency in the Teranex AV
only. Values are: Lowest Latency, Highest Quality.
Command Description
Provides auto-detection of the input video format. Must
ALWAYS be set to True. A setting of False will produce
incorrect operation of the device.
Cannot be changed by the user.
Informations pour les développeurs
340
340
Publicité
Table des Matières
