Table des Matières
Publicité
PROTOCOL PREAMBLE:↵
Version: 1.13↵
↵
TERANEX DEVICE:↵
Model name: Teranex 2D↵
↵
After the initial status dump, status updates are sent each time the status changes in the
Teranex device.
Legend
carriage return
↵
...
and so on
Orange text
Grey Text
Command Syntax
To initiate a change, the user should send the appropriate block header, followed by a full-colon
and LF, which is then followed by the specific command requested, a full-colon, the value
required, a LF, followed by a blank line. For example, to change the output video format to
1080i59.94, the user should send the following block of commands:
VIDEO OUTPUT:↵
Video mode: 1080i5994↵
↵
Response Syntax
If the command is accepted by the Teranex Server, it will respond with an ACK message. If the
request was not understood, it will respond with a NACK message.
After a positive response, the user should expect to see a status update from the Teranex
Server showing the status change. This is likely to be the same as the command that was sent,
sometimes followed by other blocks providing data specific to the change. For the above
example, the following response might be displayed:
VIDEO OUTPUT:↵
Video mode: 1080i5994↵
↵
VIDEO ADJUST:↵
Luma low: 4↵
Luma high: 1019↵
...
↵
ANCILLARY DATA:↵
AFD output line: 11↵
CC enabled: false↵
...
↵
VARIABLE ASPECT RATIO:↵
Variable Aspect Ratio size X left: 0.000000↵
Variable Aspect Ratio size X right: 0.000000↵
...
↵
Client generated
Server generated
Informations pour les développeurs
327
327
Publicité
Table des Matières
