Table des Matières
Publicité
Preset
Please note: PresetName0: refers to Preset 1, PresetName1: refers to Preset 2, etc.
Command
PresetName0:
PresetName1:
PresetName2:
PresetName3:
PresetName4:
PresetName5:
Recall:
Save:
Protocol Preamble
The Teranex Server will respond with the current protocol version.
This information cannot be changed by the user.
PROTOCOL PREAMBLE:
Version: 1.9
Teranex Device
The Teranex Server will respond with the Teranex Device command block information. None of
these items can be changed by the user.
TERANEX DEVICE:
Model name: (displays the Teranex model name)
Software Version: (displays the checksum of the installed software release)
FPGA Version: (displays the FPGA version of the installed software release)
Test Pattern
Command
Output:
No signal:
Test tone:
Command Description
Displays all current user-defined preset names.
Command is used to assign a new name to Preset 1.
Displays all current user-defined preset names.
Command is used to assign a new name to Preset 2.
Displays all current user-defined preset names.
Command is used to assign a new name to Preset 3.
Displays all current user-defined preset names.
Command is used to assign a new name to Preset 4.
Displays all current user-defined preset names.
Command is used to assign a new name to Preset 5.
Displays all current user-defined preset names.
Command is used to assign a new name to Preset 6.
Recalls a previously saved preset, 1-6. (e.g. Recall: 1)
Saves a new set of parameters to the designated preset,
1-6. (e.g. Save: 1)
Command Description
Enable video output Test Pattern. Values are: None, Black,
SMPTEBars, Bars, Multiburst, Grid
Define whether Black or Colorbars will be output when there
is a loss of input video. Values are Black, Bars
This command enables and sets the frequency for the audio
test tone in the Teranex AV only. This command is only valid
when a video test pattern is enabled. Values are: None,
Tone750Hz, Tone1500Hz, Tone3KHz, Tone6KHz
Informations pour les développeurs
338
338
Publicité
Table des Matières
