HENX H36LJ16 Mode D'emploi page 37

• Chain does not engage drive
• Blades or blade support is
Motor runs, but
chain does not
rotate.
• Bent or damaged teeth.
• Loose blade bolts.
• Debris preventing full
Chain brake
does not
engage.
• Possible chain brake
• Insufficient chain tension.
• Dull chain.
• Chain installed backwards.
Chain saw
does not cut
properly.
• Worn chain.
• Dry or excessively stretched
• Chain not in bar groove.
• Check chain tension for over
Bar and chain
running hot and
smoking. • Chain oil tank is empty.
• Debris in guide bar groove.
sprocket.
bent.
movement of the chain
kickback brake handle.
malfunction.
chain.
tightened condition.
• Re-install the chain, making sure
that the drive links on the chain
are fully seated on the sprocket.
• Replace with a new blade or
support. Contact HENX service
centre for blade or support
replacement service, found on
page 30.
• Replace with a new blade.
Contact HENX service centre for
blade replacement service, found
on page 30.
• Tighten the blade bolts. Using
a 5/16" wrench, turn the bolt
clockwise to tighten.
• Clean debris from external chain
brake mechanism.
• Contact HENX Customer Service.
• Readjust the chain tension,
following the section: "Adjusting
the chain tension".
• Sharpen the chain cutters,
following the section: "How to
sharpen the cutters".
• Re-install the saw chain, following
the section: "Replacing the bar
and chain".
• Replace the chain, following the
section: "Replacing the bar and
chain".
• Check the oil level. Refill the oil
tank if necessary.
• Re-install the saw chain, following
the section "Replacing the bar
and chain".
• Re-tension the saw chain; see
the section: "Adjusting the chain
tension".
• Filling bar and chain lubricant.
• Clear the debris in the groove.
English
37