HENX H36LJ16 Mode D'emploi page 28

English
• Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the tool.
• If any parts are damaged or missing,
please return the product to the place of
purchase. Mounting the guard cover
16. Operation
NOTICE: Recommended ambient
temperature: 0-40 degree centigrade.
WARNING: Do not allow familiarity with this
product to make you careless. Remember
that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING: Always wear eye protection with
side shields marked to comply with ANSI
Z87.1, along with hearing protection. Failure
to do so could result in objects being thrown
into your eyes and other possible serious
injuries.
WARNING: Do not use any attachments
or accessories not recommended by
the manufacturer of this product. The
use of attachments or accessories not
recommended can result in serious
personal injury.
Before each use, inspect the entire product
for damaged, missing, or loose parts, such
as screws, nuts, bolts, caps, etc. Securely
tighten all fasteners and caps and do not
operate this product until all missing or
damaged parts are replaced.
Filling oiltank with bar and chain
16.1
lubricant
WARNING: To prevent accidental starting
that could cause serious personal injury,
always remove the battery pack from the
tool before filling the tank with oil.
WARNING: Do not smoke or bring any fire or
flame near the oil or the chain saw. Oil may
spill and cause a fire.
NOTICE: The chain saw is not filled with oil
at the time of purchase. It is essential to fill
the tank with oil before use. Operating the
chain saw without chain oil or when the
oil level is below the minimum mark will
result in damage to the chain saw. Chain life
and cutting capacity depend on optimum
lubrication. The chain is automatically
lubricated with chain oil during operation.
28
a. Remove the battery pack from the chain
saw.
b. Clean the oil tank cap and the area
around it to ensure that no dirt falls into
the oil tank.
Position the chain saw on its side on a firm,
c.
flat surface, so that the tank cap is facing
upwards. Rotate the oil tank cap counter-
clockwise to remove it (See Fig. H).
d. Carefully pour the bar and chain oil into
the tank. The filter in the opening allows
the oil to seep slowly into the tank; be
careful not to let the oil spill from the
opening. Fill to the bottom of the fill
neck. Wipe off any excess oil.
Replace the cap, place the saw upright,
e.
and view the level through the oil
inspection window. Oil should fill the
window.
NOTICE:
• Use Oregon Chain and Bar oil for best
results. It is specially designed to provide
low friction and faster cuts.
• Never use oil or other lubricants not
specifically designed for use on the bar
and chain. This can lead to a clogged
oil system, which may cause premature
wear of the bar and chain.
• Check the oil level frequently and
fill when the oil level falls below the
minimum line. Never operate the chain
saw if the oil is not visible.
• Do not use dirty, used or otherwise
contaminated oils. Damage may occur to
the bar or chain.
• There is a filter inserted in the opening of
the oil tank to filter out dirt and debris.
• DO NOT remove the filter when filling the
oil tank.
• It is normal for oil to seep from the saw
when it is not in use. To prevent seepage,
empty the oil tank after each use, and
then run the saw for one minute. When
storing the tool for a long period of time,
be sure the chain is lightly lubricated; this
will prevent rust on the chain and bar
sprocket.
• To preserve natural resources, please
recycle or dispose of oil properly. Consult
your local waste authority for information