Safety Regulations - Mondolfo Ferro Super RM2 Manuel D'utilisation

The equipment is intended for professional use only.
WARNING
only one operator may work on the equipment at a time.
WARNING
Failure to observe these instructions and the relative danger warnings can cause serious
injury to the operator and others. Do not power up the machine before you have read and
understood all the danger/warning/attention notices in this manual.
This machine must be used only by qualified and authorised personnel. A qualified operator is
construed as a person who has read and understood the manufacturer's instructions, is suitably
trained, and is conversant with safety and adjustment procedures to be adhered to during ope-
rations. Operators are expressly forbidden from using the machine under the influence of alcohol
or drugs capable of affecting physical and mental capacity.
The following conditions are essential:
- The operator must be able to read and understand all the information in this manual.
- Make sure you have a thorough knowledge of the capabilities and characteristics of this machi-
ne.
- Keep unauthorised persons well clear of the area of operations.
- Make sure that the machine has been installed in compliance with established legislation and
standards.
- Make sure that all machine operators are suitable trained, that they are capable of using the
machine correctly and that they are adequately supervised during their work.
- Never leave nuts, bolts, tools or other equipment on the machine to avoid the risk that they
could become entrapped between moving parts during work.
- Do not touch power lines or the inside of electric motors or other electrical equipment until
the power has been disconnected and locked out.
- Read this manual carefully and learn how to use the machine correctly and safely.
- Always keep this user manual in a place where it can be readily consulted when working with
the machine and consult it whenever you are in need of confirmation or explanations.
WARNING
Do not remove or deface the safety Danger, Warning or Instruction decals. Replace any missing
or illegible decals. Missing or damaged decals can be obtained at your nearest MoNDoLFo
FERRo dealer.
- When using and carrying out maintenance on the machine observe the unified industrial accident
prevention regulations for high voltage industrial equipment.
- Any unauthorised alterations made to the machine automatically release the manufacturer from
any liability in the case of damage or accidents attributable to such alterations. Specifically,
tampering with or removing the machine's safety devices is a breach of the regulations for
industrial accident prevention.
WARNING
When operating or servicing MONDOLFO FERRO equipment do not wear ties, loose fitting
clothes, necklaces, rings or wristwatches that could become entrapped by moving parts.
6

SAFETY REGULATIoNS

- Operator's manual SUPER RM
- E
nglIsh