Installation On: As 933 - As 943 - As 944; Installation With Rm2 Control Arm; Installation With Rm4 Control Arm - Mondolfo Ferro Super RM2 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INSTALLATIoN oN: AS 933 - AS 943 - AS 944

• Disconnect the machine from the electricity and compressed air supply systems (fig.5).
• Disconnect the air lines from the filter-regulator unit and remove the unit, which is on the
right-hand side of the rear of the machine body (fig.6-7).
• Disassemble the side panel (fig. 8).
• Fit the SUPER RM power unit; pass the two air lines T through the openings provided and tighten
the screws (fig.9): please follow the same sequence shown in the picture in order to guarantee
a correct assembly.
• Reassemble the filter-regulator unit in the new position (fig.10).
• Reconnect the pipelines to restore the compressed air supply by connecting the two T air lines
previously positioned to the two unions of the filter-regulator unit and add the "Y" RT1 union
(fig. 11).
• Remove the front panel of the SUPER RM (fig.12).
• Grease the seat of the RM2 arm and the pivot pin F1 with Lok-cease.
• Fit the RM2 arm (fig.13): insert the pivot pin F1 in the SUPER RM and RM2
seat provided and secure with the two snap rings S1 and S2.
• Connect the pneumatic circuit (fig. 14):
- connect pipeline A (ø 8) to union RT1;
- connect the two black B and C pipelines (ø 6);
- collegare il tubo E (ø 4) al cilindro di bloccaggio;
- fasten them using straps M provided with the machine (fig. 15)
• Fit the RM3 arm (fig.17): fit the arm with disc into the seat provided in the SUPER RM and secure
it with the pivot pin F2 and the two snap rings S3 and S4.
• Remove the front panel of the SUPER RM (fig.12).
• Fit the RM4 arm (fig.18): fit the arm into the seat provided in the SUPER RM and secure it with
the pivot pin F1 and the two snap rings S1 and S2.
• Connect the pneumatic circuit (fig. 14):
- connect pipeline A (ø 8) to union RT1;
- connect the two black B and C pipelines (ø 6);
- fasten them using straps M provided with the machine (fig. 15).
- collegare il tubo E (ø 4) al cilindro di bloccaggio;
• Replace the front panel of the SUPER RM (fig.19).
• Replace the side panel (fig. 19).
• Reconnect the machine to the electricity and compressed air supply systems (fig.19).
- Operator's manual SUPER RM
- E
nglIsh

Installation with RM2 control arm

Installation with RM4 control arm

7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Super rm4

Table des Matières