Kerbl MiniSwing 18840 Mode D'emploi page 42

5.3.2 Installation steps
1. Determine the installation height (see Point 5.3.1)
2. Attach the brush to the drive unit using the four screws (Fig. 4, Item 1) and washers (Fig. 4, Item 2).
3. Install the suspension arm, including drive unit, at the determined mounting height
4. Mount the control unit on a solid and vibration-free surface.
5. If necessary, attach protection against chewing to the motor cable.
Figure 4: Mounting the brush with the drive unit.
Figure 3: Hole pattern
Figure 2: Mounting
height
42