Videotec MAXIMUS MVX Manuel D'instructions page 12

6 Configuration
The product can be configured using one of the
following tools:
Analogue versions of the product
• OSM interface (On Screen Menu): Configuration via
the text on the analogue video signal.
IP versions of the product.
• Sofware interface: Configuration via the
application installed on PC.
• Web interface: Configuration via the browser.
6.1 OSM interface (On Screen
Menu)
It is possible to enable the OSM by
connecting the grey and green signal cable
wires for 5 seconds (Tab. 3, page 8).
6.1.1 Using the OSM
During normal operation of the unit, you can activate
the OSM to select and configure advanced functions..
For further information, refer to the manual of the
keyboard used and to the relative chapter. (8.3
Special controls, page 30).
Exit the OSM with Wide Zoom (Zoom-).
10
6.1.1.1 How to use the joystick
All operations in the menus are carried out using the
joystick.
Left
Fig. 4
Browsing the menu.
Exit
Fig. 5 Wide Zoom and Tele Zoom.
If you use control keyboards with 2-axes
joystick, use the Wide Zoom and Tele Zoom
buttons to Exit and Confirm.
Up
Right
Down
Confirm
MNVCMVXCAM_1545_EN