Ultraflex UC 81 Manuel D'installation Et De Maintenance page 41

PROBLEM
Oil leakage from the cap of
the tank.
• Lack of thread sealant.
•
CAUTION
To seal the fittings do not
under any circumstances use
Teflon tape or adhesive tape.
POSSIBLE CAUSE
• Cap incorrectly screwed.
• Gasket worn or damaged.
• Too high oil level.
HYDRAULIC CYLINDER FOR OUTBOARD MOTOR
Installation and Maintenance Manual
• Empty the steering gear and
disassemble it. Remove the
fittings and clean the threads
(remove the oil). Place
the thread sealant, screw
the fittings and install the
steering gear.
•
N OTE
After this operation, it is
necessary to carry out a
new and complete bleeding
procedure.
INTERVENTION
• Screw the cap correctly.
• Replace the cap.
• Apply the oil level
maintenance procedure
described in the pump use
and maintenance manual.
41
- page