Ultraflex UC 81 Manuel D'installation Et De Maintenance page 21

2
Place the motor straight so that its arm is perpendicular to the transom.
3
Referring to the installation instructions of the arm shown in the "Application Guide",
connect the idler arm to the motor arm through the screw (4) and tighten with a torque of 30 Nm
(22,1 lb ft). Screw the self-locking nut (5) and tighten it with a torque of 25 Nm (18,5 lb ft). After
tightening the nut (5), ascertain the correct tightening torque 30 Nm (22,1 lb ft) of the screw (4).
DANGER
It is important to check periodically, at least every 3 months or every month for professional
use, the proper tightening of the screw (4) and of the self-locking nut (5).
4
Generously grease the two parts constituting the motor tube rod (6) and (7), using the
marine type grease in order to avoid oxidation of the metal parts in contact.
4
5
7
HYDRAULIC CYLINDER FOR OUTBOARD MOTOR
Installation and Maintenance Manual
6
21
- page