Publicité
Les langues disponibles
Les langues disponibles
Installation and Maintenance Manual
The fittings are mounted in parallel and with an inclination of 30°.
Screw the tubes on the cylinder fittings with a tightening torque of 20 Nm (15 lb ft) in accordance
with the following:
• 75 mm minimum bending radius of tubes
• no interference during the tilting rotation of the motor
• no interference with the transom.
NO
CAUTION
Excessive bending of the tube may result in an internal breakage compromising the smooth
operation of the system. In this case, replace the damaged tube.
WARNING
Always carefully connect the tubes as shown in the following figure.
30
page
-
CYLINDRE HYDRAULIQUE POUR MOTEUR HORS BORD
Publicité
