Publicité
Les langues disponibles
Les langues disponibles
User's Manual
1.14 Move to the Server Types tab, and make sure that PPP: Internet, Windows NT Server, Windows 98 is
selected as the Type of Dial-Up Server. Do not check any box for the Advanced options. Check only the
TCP/IP box, and do not check other boxes for the Allowed network protocols. And then click the TCP/IP
Settings... button.
1.15 Click the Specify an IP address radio box, and enter "10.10.10.12". And then click the OK button. After
you have changed the settings, you can save your changes by clicking the OK button. Selecting Cancel
returns to the previous dialog box without saving the changes.
1.16 Double click the newly created connection icon, and try to connect.
2. Dial-up Networking Setup for Callback Function
NOTE: Follow the same procedures to set up the adaptor and protocol as used in steps 1.1 to 1.8 in the
Dial-up Networking Setup for Remote Access section. Then, proceed to step 2.1 below.
2.1
Open My computer on the desktop, and select Dial-up Networking.
Click the pull-down menu
Connection, and move the cursor to Dial-Up Server and click it. If it is not listed, return to the step 1.1.
2.2 Click the Allow caller access radio box. Then, click the Server Type... button, and make sure that PPP:
Internet, Windows NT Server, Windows 98 is selected for Type of Dial-Up Server. Do not check any box for
Advanced options. You can save your changes by clicking the OK button. Selecting Cancel returns to the
previous dialog box without saving the changes.
Dial-up Networking Setup for Windows XP BASE System
1. Dial-up Networking Setup for Remote Access
1.1 In the Windows mode, go to Start on the Task Bar, and to the Control panel. Then, open Network
Connection. Double click Create a new connection.
76
Publicité
