Télécharger Imprimer la page

Capture CPT-DVR4132XP Manuel D'utilisation page 109

Publicité

Les langues disponibles

Les langues disponibles

User's Manual
Front Panel
Rear Panel
NOTE: Check the voltage selector switch is set to an appropriate position.
Turning On the DVR
Press the power button located on the front panel to turn the system on.
The system goes into the
SmartGuard mode as soon as it finishes its boot process.
CAUTION: The system will lock up if the monitor does not have high enough resolution. The DVR requires
1024x768 resolution.
Turning Off the DVR
Click the POWER button in the SmartGuard mode or press the power button on the front panel to turn the
system off.
NOTE: When turning off the system, you must confirm that you want to turn off the unit. You will also be asked
for a user ID and password, or system quit procedure if the Shut Down option was selected for the user's
authorization during SmartGuard setup.
CAUTION: The system can be shut down by force by pressing the power button on the front panel over 10
seconds. However, follow the normal shutdown procedures as mentioned above when the system is
operating normally. Turning off the DVR without shutdown procedures can cause damage to the system.
2

Publicité

loading