Publicité
Les langues disponibles
Les langues disponibles
User's Manual
NOTE: If the VGA card of a BASE system does not support the overlay function, the transmit speed can slow
down somewhat.
16.
Move to Bandwidth Limit, and check the box to control the network bandwidth. And then enter the
bandwidth limit (kbps) using either actual keyboard or the virtual keyboard.
17.
Move to Use DVRNS, and check the box to use DVRNS (DVR Name Service) server. Click the Set up
DVRNS... button displays the IP Notifier – DVRNS (DVR Name Service) dialog box allowing you to set
details about DVRNS.
NOTE: The DVRNS registration is limited to only one DVRNS server. The DVR cannot be registered to multiple
DVRNS servers.
1.
Move to DVRNS Server, and enter the IP address and port number of the DVRNS server.
2.
Move to DVR, and enter the unit name to be registered on the DVRNS server and enter the DVR
Description. Clicking the Check button next to the Name box allows you to check if the name you
entered can be used. The IP address displays the IP address of the DVR. If you want to enter the IP
address manually, check the Manual box.
3.
Help desk displays the information registered on the DVRNS server.
4.
You can save your changes, register the DVR information on the DVRNS server by clicking the Submit
button, and hide the IP Notifier – DVRNS (DVR Name Service) dialog box by clicking the Hide button.
5.
Click the Set up network... button, and set up the network. See Appendix 3 – Network Setup (LAN) or
Appendix 4 – Network Setup (Modem) for details.
6.
Click the Set up Callback... button, and set up the callback function. The DVR can be set up to notify
the target server running the SmartBase when certain events occur.
7.
Move to Use Callback, and check the box to enable the callback function.
NOTE: When using the callback function with modem connections, check the Use Modem box and then
select the installed modem to use. Also, the dial-up server should be running on the target server to be
notified. See Appendix 4 – Network Sestup (Modem) for details.
8.
Move to Center, and enter the IP address of each server. A maximum of three servers can be set.
NOTE: When selecting the Use Modem, enter the telephone number of the target sever instead of the IP
address.
24
Publicité
