Publicité
Les langues disponibles
Les langues disponibles
User's Manual
4.
Move to Sensitivity, and set the sensitivity of the motion detection (1 to 5) by holding down and dragging
the pointer. Move to Min. Blocks, and set the minimum number of blocks (1 to 100).
NOTE: The number of minimum blocks should be set less than the number of blocks within the motion
detection zone. If the user draws a rectangle with 25 blocks and sets the minimum blocks to 30, nothing will
be detected even though there is motion.
5.
Click the Save Image button to save the current image of the result as a bitmap or JPEG file to the local
hard disk drive or floppy disk.
6.
Click the Find All button to find all event results within established find conditions and then display them in
the Result list box. The image of the result can be displayed by double clicking the target event in the
Result list. Remove all entries listed in the box by clicking the Clear All button. If the clear all before apply
find all box is checked, the results before applying Find All will be removed.
NOTE If you want to find one event at a time, click the Find Next button.
Finding Sensor Detection
1.
Move to Find Range to set the find parameters.
•
user setting: Finds event logs between user-defined periods. Set the desired find beginning and
ending date/time in the From and Until boxes.
•
from first day of month: Finds event logs from the first day of this month.
•
from first day of week: Finds event logs from the first day of this week.
•
from one day ago: Finds event logs from one day ago.
•
one day: Finds event logs for one day.
2.
Click the Sensor Detection tab, and move to Target Sensor, and select from Motion/Alarm Sensor, Motion
Sensor or Alarm Sensor.
NOTE: Selecting Motion/Alarm Sensor will find event-recorded data by both motion detection and alarm
input, selecting Motion Sensor will find event-recorded data by motion detection, and selecting Alarm
Sensor will find event-recorded data by alarm input within established find parameters.
3.
Click the Save Image button to save the current image of the result as a bitmap or JPEG file to the local
hard disk drive or floppy disk.
4.
Click the Find All button to find all event logs within established find parameters and then display the
results in the Result list box. The image of the results can be displayed by double clicking the target event
in the Result list. Remove all entries listed in the box by clicking the Clear All button. If the clear all before
apply find all box is checked, the results before applying Find All will be removed.
34
Publicité
