Publicité
Les langues disponibles
Les langues disponibles
User's Manual
Safeguards on Installing and Using the CD Burning Program
•
Do not install the DirectCD or HP-DLA programs for the system safety when installing the CD burning
program.
•
Select the Buffer underrun prevention option when initiating the CD burning program. Selecting this
option can be different depending on the installing program.
•
Refer to the manual provided with the CD-R or CD-RW drive for instructions on burning the media.
SmartPager
SmartPager pages the system manager when something happens to video input, such as a video signal loss
or system reboot. SmartServer and SmartPager cannot be run at the same time because they both use the
modem. If you want to run SmartServer and SmartPager at the same time, a second modem must be
installed. To set up SmartPager, click the Setup button in the SmartGuard mode. Move to the System tab,
and click the Set up Pager... button. The following SmartPager dialog box appears.
NOTE: SmartServer is invisible software that prepares images to send to remote sites via a modem or LAN.
1.
Click the text field beside Modem port, and enter the COM port number of the modem.
2.
Click the text field beside Phone number, and enter in the pager number. Make certain to enter the
number exactly as it must be dialed including any numbers such as 9 to get an outside line or area
codes.
3.
Click the text field beside Mailbox, and enter the number for paging when the pager uses a voice
mailbox.
4.
Move to Messages, and select the paging condition. Check the box beside the events that should
cause the DVR to call the pager and enter the user-specified number in the text field. Multiple conditions
can be selected. When selecting System restart, the DVR pages whenever the system is restarted. When
selecting Video loss, the DVR pages whenever the system loses video input from a camera.
5.
Click the About... button to see the software version information.
6.
Click the Apply button to save the changes. This button is enabled when certain values are changed.
The changes are saved only when you click this button.
7.
Click the Hide button to hide the SmartPager dialog box.
8.
Click the Close button to end SmartPager.
50
Publicité
