Publicité
Les langues disponibles
Les langues disponibles
User's Manual
Move to Dwell time, and set the alarm output duration (0 seconds to 30 minutes) by holding down and
dragging the pointer.
Setting Up the Text-In (Text-In version only)
1.
Click the Text-in device icon
NOTE: Selecting 1-16 tab displays text-in channels 1 to 16 and selecting 17-32 tab displays 17 to 32.
2.
Move to Enable, and check the box to enable to use the selected text input device.
3.
Move to Use Text-In OSD, and check the box if you want to display text-in information on the image.
4.
Click the Select Text-In System button to set up the text-in device. Select the model of installed text-in
system from the Text-In Model list, and the COM port to use from the drop-down list. Click the Set up
port... button to display the Set up COM Port dialog box. Set the Baud rate from 300 to 256,000, select
the Parity from None, Even or Odd parity, select the Data bit from 7 bit or 8 bit format, select the Stop bit
from 1 bit or 2 bits from the drop-down list. You can save your changes by clicking the OK button.
Selecting Cancel exits the dialog box without saving the changes.
5.
Move to Device, and select the type of text-in device to use.
NOTE: Each type of text-in device (User Define, GnomeII and so on) has different setup options which can be
defined by the user.
6.
Move to Case Sensitive, and check the box to distinguish between capital letters and small letters from
text-in data.
7.
Move to Transaction Start, and enter the character string to be considered as transaction start. If the Any
character box is checked, preset any character will be considered as transaction start.
8.
Move to Transaction End, and enter the character string to be considered as transaction end.
NOTE: Entering multiple keywords for Transaction Start / End are supported. Use a semi-colon (;) to delimit
each keyword. When the semi-colon is included in Transaction Start / End itself, use a double semi-colon (;;).
22
.
Publicité
