Stihl SR 5600 Notice D'emploi page 15

Information Before You Start
NOTICE
With the engine stopped and before
starting, check the air intake grille
between the backplate and powerhead
for blockages and clean if necessary. A
protective screen is available as a
special accessory to keep the air intake
clear.
Move the setting lever to the idel
N
position.
The throttle cable disconnects itself from
the throttle trigger if the engine is not
shut off in the idle position.
The throttle cable reconnects itself
automatically when the setting lever is
moved to the idle position.
SR 5600
Starting / Stopping the
Engine
Starting the Engine
Observe safety precautions.
N
1
2
Slide the stop switch (1) to #
N
Move setting lever (2) to center
N
position – starting throttle.
The setting lever enables you to select
and hold any throttle position between
(lower stop) idle and full throttle (upper
stop).
Set the lever to the idle position before
switching off the engine.
Before Starting
3
Close the stop cock (3) (set to
N
upright position).
English
13