Publicité
Les langues disponibles
Les langues disponibles
The motor protection
5.
trips too frequently.
The pump does not
6.
deliver.
The pump does not
7.
prime.
The pump supplies
8.
insufficient flow.
The pump flow rate is
9.
not constant.
The pump turns in the
10.
opposite
direction
when switching off.
The pump vibrates and
11.
operates noisily.
A.
Ensure that the environment temperature is
not too high.
B.
Check the calibration of the protection.
C. Check the state of the bearings.
D. Check the motor rotation speed.
A.
The pump has not been correctly primed.
B.
On three-phase motors, check that the
direction of rotation is correct.
C. Difference in suction level too high.
D. The diameter of the intake pipe is insufficient
or the length is too long.
E.
Foot valve blocked.
A.
The intake pipe or the foot valve is taking in
air.
B.
The downward slope of the intake pipe
favours the formation of air pockets.
A.
Blocked foot valve.
B.
The impeller is worn or blocked.
C. The diameter of the intake pipe is insufficient.
D. Check that the direction of rotation is correct.
A.
Intake pressure too low.
B.
Intake pipe or pump partly blocked by
impurities.
A.
Leakage in the intake pipe.
B.
Foot valve or check valve faulty or blocked in
partly open position.
A.
Check that the pump and/or the pipes are
firmly anchored.
B.
There is cavitation in the pump (see point 8,
paragraph on INSTALLATION).
C. The pump is running above its plate
characteristics.
ENGLISH
A.
Provide
environment where the pump is installed.
B.
Calibrate at a current value suitable for the
motor absorption at full load.
C. Change any worn bearings.
A.
Fill the pump and the intake pipe with water.
Prime the pump.
B.
Invert the connection of two supply wires.
C. See point 5 of the instructions for installation.
D. Replace the intake pipe with one with a larger
diameter.
E.
Clean the foot valve.
A.
Eliminate the phenomenon, checking the
intake pipe accurately, and prime again.
B.
Correct the inclination of the intake pipe.
A.
Clean the foot valve.
B.
Change the impeller or remove the
obstruction.
C. Replace the pipe with one with a larger
diameter.
D. Invert the connection of two supply wires.
B.
Clean the intake pipe and the pump.
A.
Eliminate the fault.
B.
Repair or replace the faulty valve.
A.
Fasten any loose parts.
B.
Reduce the intake height or check for load
losses.
C. Reduce the flow rate.
19
suitable
ventilation
in
the
Publicité
