Packaging, Transport, Storage - Burkert 2301 Guide Rapide

Exhaust air port
Pilot air port
Additional exhaust air port only
with pilot-operated control
system for high air output from
(actuator size ø 130)
Fig. 8: Pneumatic connection
control air hose:
6/4 mm or 1/4" pilot air hoses can be used.
A pilot air port via G 1/8" thread is available as an option.
8.5 start-up
After installing the device, run the X.TUNE function. This function
presets the control parameters.
Description – see operating instructions for the control.
8.6 removal
Danger!
risk of injury from discharge of medium and pressure!
It is dangerous to remove a device which is under pressure due to
the sudden release of pressure or discharge of medium.
▶ Before removing a device, switch off the pressure and vent the lines.
16
3
1
3.1
english
Type 2301
Technical data
Procedure:
→
Loosen the pneumatic connection.
→
Remove the device.
8.7 maintenance work
→
Complete a visual inspection of the equipment once a year. Shorter
maintenance intervals may be recommended depending on the
operating conditions.
Wear parts: seals and swivel plate.
→
In the event of a leak, replace the relevant wear part.
The maintenance and repair instructions are available on the
Internet: www.burkert.com
9 PackaGinG, TransPorT,
sToraGe
note!
transport and storage damage!
• Protect the device against moisture and dirt in shock-resistant
packaging during transportation and storage.
• Permitted storage temperature: -20...+65 °C.
damage to the environment caused by device components
contaminated with media.
• Ensure the device and packaging are disposed of in an environ-
mentally sound manner!