Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4) Attach the pole to the wall with four 8 mm threaded rods plus chemical sealing
(recommended).
5) Attach the double side frame to the polewith
the TWO 8 mm screws (C). Do not forget to
feed the cables through pole.
6) Open the clocks and remove the wall
mounting parts.
7) Attach the first clock (repeater clock) to the
double sided frame on the 4 screws ST F M5-
40 (D). Place the 6 mm washers (detail D)
flat on the frame (and not inside the clocks)
to move the clocks sufficiently far away and
facilitate insertion of the cables. Screw in the 2
nuts at the top (D) without tightening, move the
clock away and insert the cables.
8) Attach the second clock (master clock) on
the other side of the frame with the same 4
screws ST F M5-40 (D). Screw in the 2 nuts at
the top (D) without tightening, move the clock
away and insert the cables. Refer to section III
Electrical Installation.
Stainless steel 8 mm
tooth washer
St. steel nut HU M8
Pole
C
Vertical mounting
Horizontal mounting
St. steel nut HM5
St. steel screw
ST F M5-40
St. steel 6 mm
flat washer
Cover for single sided mounting
C
St. steel screw
H M8x25
Pole
C
D
23
Publicité
Table des Matières
