Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5) Attach the pole to the wall with four 8
mm threaded rods plus chemical sealing
(recommended).
6/ Attach the double sided frame to the polewith
the two 8 mm screws (detail C). Do not forget to
feed the cables through the pole.
7/ Open the clock and remove the wall mounting
parts.
8/ Attach the clock to the double sided frame
on the 4 screws ST F M5-40 (detail D). Place
the 6 mm washers (detail D) on the frame
(and not inside the clocks) to move the clocks
sufficiently far away and facilitate insertion of
the cables. Screw in the 2 nuts at the top (D)
without tightening, move the clock away and
insert the cables.
9/ When the cables are correctly positioned,
tighten the 4 nuts (D) of the clock .
Recommendation for installation in «right flag»
1) When leaving our factory the Style 12E and Style 12SE HF radio models are equipped with a
radio antenna mounted on the right flank.
By default, the installation of the antenna on the right flange is suitable for wall mounting on «left
flag» bracket.
2) In the case of mounting as «right flag,» it is essential to swap the right side with the left in
order to install the bracket (see page 19 to remove the flanges).
Antenna
Mounted on the
left flank
Stainless steel 8 mm
tooth washer
Vertical mounting
Horizontal mounting
Stainless steel nut HM5
St. steel screw ST F M5-40
St. steel 6 mm flat washer
Reverse the right flank with the left flank
C
Stainless steel
nut HU M8
Pole
C
D
D
D
Cover for single sided mounting
Antenna
Mounted on the
right flank
Stainless steel
screw H M8x25
Pole
C
21
Publicité
Table des Matières
