Ordering Spare Parts - Burkert 6203 EV Manuel D'utilisation

note!
Device will be damaged if the wrong tools are used!
Always use a wrench to tighten nut. If other tools are used
(e.g. pliers), the device may be damaged.
Nut
Core guide tube
O-ring
Observe torque!
(see table below)
Fig. 3: Coil installation
Torque for fastening nut:
Coil type Coil width
AC10 32 mm or 40 mm
english
20
9. sparE parTs
Caution!
Risk of injury and/or damage by the use of incorrect
parts!
Incorrect accessories and unsuitable spare parts may cause
injuries and damage the device and the surrounding area.
• Use original accessories and original spare parts from
Bürkert only.

9.1. Ordering spare parts

Replacement part sets
When ordering replacement part sets, quote the sets SET 1,
SET 3 or SET 7 and the identification number of the device.
• See replacement part sets 9.2. and 9.3
• The identification number of the device can be found on
the type label. See also chapter "6.2. Type label".
english
22
Torque [Nm]
5 Nm
8.3. malfunctions
If malfunctions occur, check whether:
→
the device has been installed according to the
instructions,
→
the electrical and fluid connections are correct,
→
the device is not damaged,
→
all screws have been tightened,
→
the voltage and pressure have been switched on,
→
the pipelines are clean.
Valve does not switch
Possible cause:
• Short circuit or coil interrupted,
• Core or core area dirty.
• Medium pressure outside the permitted pressure range.
Valve does not close
Possible cause:
• Internal space of the valve is dirty.
• Small control bore in the diaphragm blocked.
9.2. Overview of replacement part
sets Type 6203 EV, dn 10,
dn 13
Fig. 4: Replacement part sets Type 6203 EV
Type 6203 EV
english
21
Coil set
SET 1
Plunger tube set
SET 7
Wearing-parts
set SET 3
english
23