Dentsply Maillefer ENDOACTIVATOR Protocole D'utilisation page 5

6.2) BATTERY REPLACEMENT
The EndoActivator handpiece comes with one (1) "AA" alkaline battery.
6.3) Replacement parts
Battery Housing Replacement Part
In case of failure on the removable battery housing, you can order a replacement part ref.: A0915
Rocker arm replacement kit
In case of broken distal end of the rocker arm, you can order a replacement part ref.: A0916
6.4) DISINFECTION
For infection control, select the appropriately sized EndoActivator tip and remove it from the plastic
package. The Activator tip should be cleaned and disinfected, with a gauze moistened with a
disinfecting solution such as sodium hypochlorite.
IMPORTANTLY, the Activator tips are intended for single-patient use only.
Use a barrier sleeve over the entire handpiece. Upon removing the barrier sleeve, the outer surface of
the handpiece may be wiped down with a mild detergent or disinfecting solution. DO NOT submerge
the handpiece in any disinfecting solution or autoclave. Never over-saturate the handpiece with any
disinfecting solution.
ZF1902109.X / 03/ 2009 –updated 03/2011
Chemin du Verger 3
CH 1338 Ballaigues
Switzerland
www.dentsplymaillefer.com
• To remove the battery housing, firmly grasp the contra-angled portion of the
handpiece with one hand and begin turning the non-removable, screw knob
counterclockwise with your other hand.
• Rotate the screw knob counterclockwise to progressively disengage the
battery housing and remove it from the handpiece. Replace with a high
quality lithium battery.
• To close compartment, slide housing over the new battery and position the
EndoActivator logo as pictured above. ALIGN the orientational tracks within the
grooves, and turn the screw knob clockwise until snug.
5/94