Commissioning And Use; Door Opening; Lighting For The First Time - Palazzetti ELSA Généralités - Avertissements - Installation - Entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7 COMMISSIONING AND
USE
7.1

DOOR OPENING

Open the door using the handle (A) supplied. Carefully
insert the tool in the appropriate side seat paying attention
not to damage the glass and twist it upwards to open the
door and downwards to close it.
The door should be opened gradually so the smoke can
be drawn up the ue and not in the room. When lighting
the replace, and until it reaches the right temperature,
it should burn for a few minutes with the door ajar so that
the condensation that forms on the glass can evaporate.
Once the re is burning well, close the door to optimise
yield and consequently, wood consumption.
7.2

LIGHTING FOR THE FIRST TIME

Check that all moving parts are suitably placed and the air
control valve and smoke diaphragm work properly.
The rst lighting (after the installation or at the beginning
of the season) must be made with reduced loads (~ 1
kg/h) keeping the device on for at least 4 hours at low
rate. Proceed with these feed rates for at least three days
before using the appliance at its full capacity. This will
allow for the evaporation of any moisture accumulated
in the refractory elements when not used.
Light the re using old and nely chopped wood so
that the ame develops as much as possible. Once
the re is going well you can use larger pieces of
wood provided they are dry.
The rst time you light the replace smoke and unpleasant
odours might form and escape due to the complete drying
of some of the materials used. This phenomenon will
gradually disappear.
FLUE DRAUGHT -
Never use alcohol, petrol, kerosene or other liquid fuels
to light the re. Keep these substances away from the
re. Do not use petrol or chemical origin re-lighters
as they can seriously damage the walls of the rebox.
Only use ecological re lighting aids.
Do not touch the painted parts during the rst lightings
to avoid damaging the paint nish.
During the rst lightings, we recommend that you
keep the premises well ventilated.
22
00 477 6020- 10/2017 - PALAZZETTI - PN - Italy
2
1
-
+
A
- 7.1 -
- 7.2 -

Publicité

Table des Matières
loading

Table des Matières