Nz150-Kt Kit; Nsk6 Optional Screen Kit - Napoleon HIGH COUNTRY 6000 Instructions D'installation Et D'utilisation

E.
Connect the 6" (152mm) liner to the appliance and blower collars. Secure using 3 screws on each end
and seal with caulking.
Liner supplied stretches to a maximum of 10' (3.1m).
F. Insert the fi lter into the grill. Foam gasket [
housing is recommended, but not supplied.
The blower fi lter is washable.
G. The bottom lip of the grill latches over the bottom lip of the housing. Use 2 screws to secure the top of
the grill to the facing.

7.10 NZ150-KT kit

The circulation air inlet pipe must terminate outside of the
appliance enclosure to ensure proper air fl ow around the
fi rebox.
The 6" (152mm) circulation air inlet pipe may be connected to
either the NZ64 blower kit or the NZ150-KT kit.
Avoid terminating higher than the bottom of the doors on the
appliance to prevent air fl ow reversal.
An optional opening is covered on the other side of the
appliance. If this location is preferred, switch the cover plate
and collar.
7.11

NSK6 optional screen kit

Use the screen when you are in the room to enjoy the ambience of an open, wood crackling fi re.
Medium sized wood loads should be used to prevent logs from rolling against the screen.
Chimney action may not allow the screen to be used in some installations due to the resulting smoke spillage.
Opening the by-pass damper may help prevent smoke spillage. Wood will burn at a faster rate and heat
output will be less with the screen compared to the stove operation with the glass doors closed.
/ " (13mm) weather stripping] between the grill and blower
1
2
fi nishing
31
W415-1501 / G / 05.10.22
EN