Door Handle Installation; Door Installation - Napoleon HIGH COUNTRY 6000 Instructions D'installation Et D'utilisation

fi nishing
EN
7.4

door handle installation

RIGHT DOOR HANDLE (OPERATING)
Insert the door rod through the round hole
A.
of the latch, ensuring the fl at edge of the
D-shaped hole points towards the hinges.
Slide the end of the door rod through the
B.
bushing at the top of the door, as shown.
Insert the handle shaft through the door and
C.
latch.
Secure with 2 fl at washers and a nut.
D.
Feed the handle through the handle spacer
E.
and into the handle shaft.
note:
You may need to move washers to the other side of
the latch to obtain suffi cient door seal.
LEFT DOOR HANDLE (FIXED)
Insert the handle shaft through the door.
A.
Secure with a lock washer, 2 fl at washers, and
B.
a nut.
Feed the handle through the handle spacer
C.
and into the handle shaft.
note:
The fi nal angle of the left door handle should mirror
the right door handle in the closed position. Tighten
the nut to secure the left handle at the desired angle.
7.5

door installation

Place brass washers onto the faceplate hinge bushing.
A.
note:
2 extra washers are supplied in order to level the doors if
needed.
Slide the door hinge pin into the faceplate hinge bushing.
B.
To remove the doors, open them slightly and lift them out
C.
of the faceplate hinge bushings.
26
W415-1501 / G / 05.10.22